900VA SGTC

The Tesla Primary usually consists of a spiral, or inverted conical coil of wire or tubing. Copper tubing is often used because at the frequency of operation of a Tesla Coil current tends to flow over the surface of conductors, so the inner core becomes redundant. Large diameter tubing or wire are used to keep the resistance of the coil low at the operating frequency.

The Primary was wound in an inverted conical section of about ten degrees. This inverted conical primary should give better power transfer. 15 turns soft copper  tubing with a diameter of 3/8" and a spacing of 3/8" between the conductor surfaces and a spacing of 2" between the primary and Secondary. Tab on pictures to enlarge.